Verilink FrameStart FSM (34-00299.E) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 34)

3-10 FrameStart FSM

Figure 3.8

Serial Screen

Type

Selects the type of interface (based on its electrical signal characteristics) used

by the equipment connected to the Serial port.

Values: V.35, RS-232, EIA-530

Default: V.35

NOTICE: V.35 requires the use of an optional cable. Refer to "Optional

Equipment" on page A-5 for ordering information.

Mode

By default, the Serial port serves as a DCE port in both Packet and TDM

modes. However, the Serial port can serve as a DTE port when in Packet

mode.

If the Serial port connects to a DTE device (such as a FRAD or a router), the

Mode parameter must be set to “DCE.” If this port connects to a DCE device

(such as a DSU/CSU), this parameter must be set to “DTE” (valid only for

Packet mode, not TDM).

Values: DCE, DTE

Default: DCE

NOTICE: DTE mode requires the use of an optional DTE cable. Refer to

Appendix A for ordering information.

Packet Rate

If the port is running in Packet mode, the Packet Rate must be configured to

the desired port speed (in bits per second). In TDM mode, the port speed rate

will be set by configuring the next four parameters (Start Channel, Number of

Channels, Bundling, and Channel Rate).

Values: Nx56K or Nx64K where N = 1-32

Default: 1536 kbps

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 152 153

Brak uwag

Verilink FrameStart FSM (34-00299.E) Product Manual Instrukcja Użytkownika Strona 34