Verilink QUAD DATA (880-503319-001) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 20)

Quick Set-Up

2-6 Verilink QUAD DATA User Manual

Adding a Circuit

Type “A” to access the

Add Circuit Menu

. See Figure 2-5.

Figure 2-5 Add Circuit Menu

1. Use the

command to give the circuit a name. For the first

circuit use “QUADDATA_P1”.

2. Use the

command to set the mode to 64K, this means that

for each DS0 timeslot used, we will use the full 64K of

bandwidth.

NOTE:

When mapping a data port to a T1 network port connected to

an AMI T1 facility, use 56K for the mode option.

3. Use the

command to set the source port to shelf 1, slot 3,

data port 1. When configuring a circuit to a QUAD DATA

module, DS0 timeslots are not specified. The data rate is set

when the network port is configured.

4. Use the

command to set the destination port to shelf 1, slot

2—the M1-3 multiplexer module. New fields appear on the

menu,

DMDM

for destination port DS0 mapping and

DTDT

for

destination port T1 mapping.

5. Use the

command to select all 24 DS0s and use the

command to select T1 number 4 of the 28 available virtual T1

circuits.

6. When the Setup command is used, the SCM will select the

midplane bus for this circuit.

7. Type “S” to setup the circuit. A message should appear

Successful Circuit Build

Successful Circuit BuildSuccessful Circuit Build

Successful Circuit Build

This completes the configuration of the first example circuit. For

the next circuit, begin by cloning from the existing circuit.

-- ADD CIRCUIT MENU [1,1] SCM Firmware 1.12 --

-- ADD CIRCUIT MENU [1,1] SCM Firmware 1.12 ---- ADD CIRCUIT MENU [1,1] SCM Firmware 1.12 --

-- ADD CIRCUIT MENU [1,1] SCM Firmware 1.12 --

N) name: -- M) mode: --

N) name: -- M) mode: -- N) name: -- M) mode: --

N) name: -- M) mode: --

SP) src port: [-,-] undefined DP) dst port: [-,-] undefined

SP) src port: [-,-] undefined DP) dst port: [-,-] undefinedSP) src port: [-,-] undefined DP) dst port: [-,-] undefined

SP) src port: [-,-] undefined DP) dst port: [-,-] undefined

--port rate selection-- --port rate selection--

--port rate selection-- --port rate selection-- --port rate selection-- --port rate selection--

--port rate selection-- --port rate selection--