Verilink WANsuite 5130 (34-00298.L) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 51)

Web Server Interface 3-19

NOTICE: Diagnostic Messages must be set to “Enable” for the Verilink

Configuration Wizard to work.

Parity

Sets the parity bit.

Values: None, Odd, Even

Default: None

Stop Bit

Selects the number of bits required to end the character.

Values: 1, 2

Default: 1

Current Pin Status

The Current Pin Status, which shows the state of the RS-232 pins, is also

displayed on the Supervisory interface screen.

DTR Alarm Control and Status Table

In addition to the configurable fields, the Supervisory screen displays a table

that lets you set the Data Terminal Ready (DTR) Alarm Control parameters

and view the current DTR Alarm Status.

Choices for DTR Alarm Control are “Enable” and “Disable”; the default

setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit

to go into alarm on a loss of DTR, which occurs when the Serial port detects

that the DTR signal is low. The DTR Status field indicates the current state of

the DTR alarm.

Services Screen

The Services screen (Figure 3.15) displays the unit’s defined services and the

Interface, Type, Pair, and Status parameters for each service.

Figure 3.15

Services Screen

The Status for a particular service will display as one of the following:

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 262 263

Brak uwag

Verilink WANsuite 5130 (34-00298.L) Product Manual Instrukcja Użytkownika Strona 51