Verilink WANsuite 7205 (34-00317.B) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 138)

4-16 WANsuite 7205

DHCP Client

If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and

Gateway addresses from a DHCP server located on the LAN side of the unit,

and the unit will use these addresses. If the DHCP request is unsuccessful, the

unit will use the configured addresses shown on this screen.

Client Identifier

Displays a unique identifier for a specific IP address.

Physical Address

Displays unique MAC address.

NOTICE: Always verify that a DHCP server is available on the network before

enabling DHCP Client. If, on power-up, a DHCP server is not found, a

60-second timeout will occur.

NOTICE: To use newly established IP parameters, you must “Save and Restart.”

(See Save and Restart on page 4-5.)

Supervisory Config Screen

The Supervisory Config screen (Figure 4.12) displays the current speed of the

Supervisory port interface, and other asynchronous parameters.

Figure 4.12

Supervisory Config Screen

Speed

Used to change the Supervisory port speed (in bits per second).

Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200

Default: 19200

Character Size

Selects the number of bits required to make up one asynchronous character.

Values: Five, Six, Seven, Eight

Default: Eight

Parity

Sets the parity bit.

Values: None, Odd, Even

Default: None

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 220 221

Brak uwag

Verilink WANsuite 7205 (34-00317.B) Product Manual Instrukcja Użytkownika Strona 138