Verilink WANsuite 5230 (34-00304.F) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 136)

4-20 WANsuite 5260/5230

Virtual interface, you must supply an endpoint over which to send PPP

encapsulated data, and that endpoint must be for a Frame Relay DLCI.

Type

Selecting one of the services listed under the “Type” column will bring up a

screen where you can view (and, in some cases, change) parameters for each

type of service. The details displayed depend on the type of service currently

in effect. These screens are shown and described below according to each

type of service.

Pair

User-assigned integer field that specifies where to route the traffic from this

service. If the service is terminated by the unit, set this value to “0” (zero).

Delete Service

Select the “Delete Service” prompt to remove the currently configured service

identified by the Service Details screen. Deleting the selected service will

remove all references to this service.

After selecting “Delete Service,” you will be presented with a confirmation

screen similar to the one shown in Figure 4.5. Select “Yes” to confirm

removal of the selected service.

DS0 Monitor Details Screen

To access the DS0 Monitor Details Screen (Figure 4.16), click on “TDM” in

the <Type> column on the Service Table screen. This screen lets you

configure what are considered high and low DS0 utilization parameters, and

will report alarms if the monitored statistics rise above or fall below those

specified settings. This helps determine customer load patterns so that channel

bandwidth can be reallocated as necessary.

Figure 4.16

DS0 Monitor Details Screen

Number of DS0s

Number of active DS0s (0−24) assigned on a per-service basis.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 232 233

Brak uwag

Verilink WANsuite 5230 (34-00304.F) Product Manual Instrukcja Użytkownika Strona 136