Verilink WANsuite 5230 (34-00304.F) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 210)

5-14 WANsuite 5260/5230

Figure 5.14

Network 1 or Network Configuration Menu Tree

The Network 1 or Network interface can have independently selected values

for the following parameters:

Framing

Selects the framing for the network side of the DSU/CSU.

Values CCS, CAS, Unframed

Default:CCS

Coding

Sets the network side line coding.

Values: HDB3, AMI

Default:HDB3

Timing

Sets the timing source to synchronize the unit’s internal timing generators. In

all cases, slips are controlled to occur on frame boundaries at the Network

ports when timing synchronization is lost. Choices are as follows:

Network 1 (5260) − Int, Net 1, Net 2, Serial 1, Serial 2

Network 2 (5260) − Int, Net 2, Serial 2

Network (5230) − Int, Net, Serial

Definitions of the timing sources are as follows:

Internal – The unit’s internal frequency standard (E1 2.048 Mbps ± 50 bps)

is used for all timing.

Network 1, Network 2, Network – Timing is derived from the Network port

recovered clock.

Serial 1, Serial 2, Serial – Timing is derived from the Serial port recovered

clock.

CRC4 Mode

Provides line integrity detection to determine if bit errors are present on the

line.

Values: Disable, Enable

Default:Disable

Network 2 Configuration Menu (5260 Only)

Use the NET 2 CONFIG to set up parameter values for the DSX port labeled

as “

NET #2” on the WANsuite 5260.

Net 1

Config

Framing Coding Timing

CCS

CAS

Unfrmd

HDB3

AMI

CRC4 Mode

Dis

Int

Net 1

Net 2

Serial 1

Serial 2

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 232 233

Komentarze do niniejszej Instrukcji

Brak uwag

Verilink WANsuite 5230 (34-00304.F) Product Manual Instrukcja Użytkownika Strona 210

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Verilink WANsuite 5230 (34-00304.F) Product Manual