Verilink WANsuite 5650 (34-00314.E) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 19)

About the WANsuite 5650 1-7

Supervisory Port

The

SUPERVISORY PORT

is a DB-9 female DCE connector configured for 8

bits, no parity, and 1 stop bit. Bit rates are configured through the unit’s

VT100 interface. The Supervisory port speed can be set to 1200, 2400, 4800,

9600, 19200, 38400, 57600, or 115200 bps. The initial default rate of the

Supervisory port is 38400 bps.

On power-up, the Supervisory port sends out diagnostic messages at the bit

rate of 115.2 kbps until the supervisory service acquires the Supervisory port,

after which the port speed is changed to the setting in the Supervisory

interface screen.

NOTICE:

For information on pinout assignments for this connector, refer to

"Supervisory Port Pin Assignments" on page A-8. See "Ordering

Information" on page A-6 for information on cables for this connector.

Serial Interface

The

SERIAL INTERFACE

located on the rear of the WANsuite 5650 is a multi-

protocol interface presented physically as a DB-25 connection. The protocols

supported by this interface are V.35, V.36, and X.21.

Cables that adapt the DB-25 interface to the 34-pin V.35 interface are

available. These cables are optional equipment and their part numbers are

listed in

Ordering Information

on page A-6. DB-25-to-DB-25 cables are also

available if your installation requires them. Refer to

Ordering Information

page A-6 for details. Pin assignments for the serial interface are also listed in

Appendix A, "

Specifications"

CAUTION:

FCC rules require that interconnecting cables carrying high-speed data

be appropriately shielded to minimize radio frequency interference.

G.703 Port

The

G.703

port connection on the rear panel of the WANsuite 5650 is a

standard eight-pin modular jack with a receive signal level of -27 dB that

terminates as 120 ohms. To view the pinout assignments for these interfaces,

refer to

G.703 Connector Pin Assignments

on page A-8.

SHDSL Port

The

SHDSL

port connection on the rear panel of the WANsuite 5650 is a

standard eight-pin modular jack with a receive signal level of -24 dB that

terminates as 135 ohms. To view the pinout assignments for this interface,

refer to

SHDSL Interface Pin Assignments

on page A-8.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag

Verilink WANsuite 5650 (34-00314.E) Product Manual Instrukcja Użytkownika Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Verilink WANsuite 5650 (34-00314.E) Product Manual