Verilink 8100A (34-00237) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 112)

4-38 8000 Series

Enable/Disable CopperMountain CMCP

NOTICE: When using a CopperMountain DSLAM, CMCP allows the DSLAM to

configure many IAD parameters automatically. IAD parameters

controlled by CMCP include fragmentation and voice gateway support.

For more information, refer the CopperMountain DSLAM guide.

1 Type “4” on the Frame Relay Options menu. The IAD displays the CMCP

status and prompts you to change it.

2 Type “E” to enable CopperMountain CMCP or “D” to disable.

Configure Priority DLCI

Type “5” on the Frame Relay Options menu to configure a DLCI’s priority.

The IAD prompts you to enter a new priority DLCI.

Router Configuration

This section describes how to configure the IAD as a router. You may

configure the IAD as a router or a bridge, depending on your application.

Optionally, you may also configure some ports for routing and some ports for

bridging. For example, you might use a bridge connection for Internet traffic

and use a separate routed port for remote management. Alternatively, you can

configure the bridge port on the WAN side with IPoBridge to use the bridged

connection for remote management. Refer to Basic Bridge Setup Tasks on

page 4-53.

A router is a network layer device that uses one or more metrics to determine

the optimal path along which network traffic should be forwarded. Routers

forward packets from one network to another based on network layer

information.

A router generally improves overall efficiency for a complex network, but a

bridge provides better speed and flexibility for the overall network.

Basic Router Setup Tasks

To configure the IAD as a router, complete the following tasks:

• Configure IP addresses on the LAN and WAN ports (page 4-40)

• Enable RIP poisoned reverse (recommended) (page 4-45), add a static route

(page 4-43), or add a default route (page 4-44)

• Disable bridging globally (page 4-56) or by port (page 4-56)

• Disable Spanning Tree Protocol (Spanning Tree) globally (page 4-57) or by

port (page 4-58)

Use the flowchart below to plan your tasks, based on your router

configuration requirements.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 310 311

Brak uwag

Verilink 8100A (34-00237) Product Manual Instrukcja Użytkownika Strona 112