Verilink WANsuite 6450 (34-00326) Product Manual Instrukcja Użytkownika Pobierz pdf (Strona 109)

VT100 Interface 4-1

C HAPTER

HAPTER

VT100 I

NTERFACE

Introduction

This chapter describes the menus and options associated with the WANsuite

6450’s VT100 interface. You can access the VT100 interface locally via the

Supervisory port or remotely through a TELNET session.

To access the VT100 screens locally, verify the Supervisory type is “tty” and

the Supervisory port speed matches the terminal emulation program that’s

being used. The default for the Supervisory Port is 19200, 8, N, 1. (Port

speeds supported include the following: 1200, 2400, 4800, 9600, 19200,

38400, 57600, and 115200 bps.)

You can access the VT100 interface remotely by opening a TELNET session,

entering the unit’s IP Address, and connecting to the unit. All screens in this

chapter were captured during a TELNET session.

Screen Components

The VT100 terminal screens have components common to all screens (see

Figure 4.1 below). These components include the device type (in the example

below, Verilink WANsuite 6450), which is centered on the screen, the

software and hardware revision numbers (upper left), the date and time (upper

right), the menu title (“Main” in the figure below), and the serial number

under which the unit is operating.

Figure 4.1

VT100 Terminal Screen Components

Cursor Controls

The VT100 interface uses a blinking cursor to select various menus and then

to select sub-menus and/or fields within those menus. You can navigate using

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 204 205

Brak uwag

Verilink WANsuite 6450 (34-00326) Product Manual Instrukcja Użytkownika Strona 109