Verilink WANsuite 6450 (34-00326) Product Manual Instrukcja Użytkownika Strona 179

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 205
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 178
VT100 Interface 4-71
Forward
Transmissions
Number of times this port has changed from any other state to a “Forwarding”
state.
Input Frame
Number of frames received.
Output Frame
Number of frames transmitted.
Input Discards
Number of frames discarded.
TFTP Configuration
A Trivial File Transfer Protocol (TFTP) service on a server can provide
remote file access to the WANsuite 6450 to
Update the firmware on a WANsuite unit
Save the configuration setup of a WANsuite unit
Restore a saved configuration setup to a WANsuite unit
To transfer a file to or from a TFTP server from a WANsuite unit, you must
indicate the TFTP server’s IP address and file name, and then perform a Get
operation to receive a file from the server, or a Put operation to send a file to
the server. The file name and its extension determine the type of file
transferred.
The table below shows the possible file operations.
Note that when updating the application software using a .HEX file, the file
name should have the form xxAPxxxx.HEX; the AP indicates the file is an
application load. When updating the boot software, the file name should have
the form xxWBxxxx.HEX; the WB indicates the file is a boot load.
Operation File Name Extension Action
Update Application Firmware .CHX or .HEX(1) Get
Update Boot Firmware .HEX(2) Get
Save Configuration Setup .CFG Put
Restore Configuration Setup .CFG Get
Przeglądanie stron 178
1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 204 205

Komentarze do niniejszej Instrukcji

Brak uwag