Verilink WANsuite 6x30 (34-00315.B) Product Manual Instrukcja Użytkownika Strona 144

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 181
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 143
4-46 WANsuite 6x30
Please note that not all parameters are necessarily defined, depending on
whether or not the routes were learned dynamically. Primarily, the most
useful information is included in "Destination," "If Ndx," and "Mask"
columns.
Figure 4.42
Dynamic Route Table Screen
Destination
Network to be reached.
If Ndx
Interface internal number.
Next Hop
IP address used to reach the destination network.
Type
Direct or Indirect.
Protocols
Local
Age
0
Mask
Mask of the destination network.
Static ARP Table Screen
ARP (Address Resolution Protocol) is used by the router to dynamically
associate a high-level IP address to a low-level physical hardware address.
ARP packets are only sent across a single physical network.
There are some cases when an IP-compatible device does not support ARP or
ARP is deliberately disabled (for security). In these cases, instead of using
ARP to dynamically update the router internal MAC <-> IP Address Table,
this menu can
force
an entry into that table. This entry never times out.
At least one circuit must be defined to create a Static ARP Table entry because
an ARP entry is always associated with a circuit.
The static ARP table is useful
Przeglądanie stron 143
1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 180 181

Komentarze do niniejszej Instrukcji

Brak uwag