Verilink WANsuite 6x30 (34-00315.B) Product Manual Instrukcja Użytkownika Strona 22

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 181
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 21
1-6
WANsuite 6x30
The rear panel of the WANsuite 6230 has seven connectors. From left to
right, these are as follows:
POWER
,
SUPERVISORY PORT
,
10/100 ETHERNET
,
SERIAL
, and
NET (75
Rx), NET (75
Tx), NET (120
)
as shown in
Figure
1.3 below. The WANsuite 6230 has one E1 port to which you may connect
using
either
the 75-ohm BNC
or
the 120-ohm RJ-48C.
Figure 1.3
WANsuite 6230 Rear Panel
The rear panel of the WANsuite 6430 has five connectors. From left to right,
these are as follows:
POWER
,
SUPERVISORY PORT
,
10/100 ETHERNET
,
SERIAL
,
and
NETWORK
as shown in Figure 1.4 below.
Figure 1.4
WANsuite 6430 Rear Panel
Supervisory Port
The
SUPERVISORY
port
is a DB-9 female DCE connector configured for 8
bits, no parity, and 1 stop bit. Bit rates are configured through the Web server
interface. (See
Supervisory Screen
on page 3-26.) The Supervisory port speed
can be set to 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 bps.
The initial default rate of the Supervisory port is 19200 bps.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the Supervisory service acquires the Supervisory port,
after which the port speed is changed to the setting in the Supervisory
interface screen.
NOTICE:
For information on pinout assignments for this connector, refer to
Supervisory Port Pin Assignments on page A-13. See Standard
Equipment on page A-10 for information on cables for this connector.
10/100 Ethernet
The WANsuite 6x30
units
p
rovide a single
10/100 ETHERNET
interface for IP
Gateway, SNMP, and Web browser access. This interface is an eight-pin
modular jack that complies with standard twisted-pair, 10/100Base-T
requirements. The 10/100Base-T cable is supplied by the end user. Refer to
Ethernet Connection Pin Assignments
on page A-12 for pin assignments and
cable descriptions.
Przeglądanie stron 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 180 181

Komentarze do niniejszej Instrukcji

Brak uwag