
Installation
6
Using the Tab key again, move the cursor to the “IP Address” field and
enter the appropriate IP address for the unit (
xxx.xxx.xxx.xxx
repeat this process for the “Subnet Mask” and “Gateway Address” fields.
7
Next, move the cursor to the “Write To Unit” field and press the Enter key.
The program will prompt you to reset the unit.
8
To reset the unit, press the
RESET
button on the unit’s front panel. The
Configuration Wizard will then automatically download the configuration
9
Note the status messages displayed at the bottom of the Configuration
Wizard screen. When the download is complete, your PC will beep and the
status message bar will display “Finished.”
10
Finally, move the cursor to the “Exit” prompt and press Enter. The
Configuration Wizard program will close.
Komentarze do niniejszej Instrukcji