Verilink WANsuite 6x30 (34-00315.B) Product Manual Instrukcja Użytkownika Strona 23
- Strona / 181
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
About the WANsuite 6x30
1-7
Ethernet LED Indicators
There are two unlabeled indicator LEDs on either side of the 10/100 Ethernet
jack. The LED on the left side of the jack pulses amber to indicate data
activity (either transmit or receive). The LED on the right side of the jack
lights green to indicate that the link layer is operational.
Serial Interface
The
SERIAL
interface located on
WANsuite 6x30 rear panels is
a multi-
protocol interface presented physically as a DB-25 connection. The protocols
supported by this interface are RS-232, V.35,
EIA-530,
and
(on the 6230
only)
X.21.
Cables that adapt the DB-25 interface to the 34-pin V.35 interface are
available. DB-25 to DB-25 cables are also available if your installation needs
require them. See
Standard Equipment
on page A-10 for
details. Pin
assignments for the Serial interface are
listed in
Serial Interface Pin
Assignments, DTE Mode (Packet Use Only)
on page A-11
and
Serial Interface
Pin Assignments, DCE Mode
on page A-12
.
CAUTION:
FCC rules require that interconnecting cables carrying high-speed
data be shielded appropriately to minimize radio frequency
interference.
Network Interface
The WANsuite 6x30 units have one rear panel
NETWORK
connection
.
On the
WANsuite 6130 and 6430, this connection is a standard RJ-48C, eight-pin
modular jack that terminates as 120 ohms. The WANsuite 6230’s Network
port is accessible through
either
the 75- or 120-ohm jack. The 75-ohm
connectors are standard BNC jacks, while the 120-ohm connector is a
standard RJ-48C right-pin modular jack. Both 75- and 120-ohm jacks will
receive a signal level to
−
27 dB to its appropriate termination impedance.
To view the pinout assignments for these interfaces, refer to
Network Interface
Pin Assignments
on page A-13.
Power Connection
The
POWER
port on the WANsuite 6130 and 6230 units
is an eight-pin
circular mini-DIN connector that connects the autoranging 100–240 VAC or
18
−
150 VDC external power supply to the unit. The WANsuite 6230 is
intended to be used with a CE Marked power supply with a minimum output
rating of 4.0 A at +5 VDC. The unit has no power switch.
The
POWER
port on the WANsuite 6430 unit
is a standard, grounded, three-
prong connector. This 110/220 VAC power receptacle is rated at 50–60 Hz,
0.2 A/0.1 A. To apply power to the unit, simply plug the supplied power cord
- WANsuite 1
- Reference Manual 1
- Copyright Notice 2
- Documentation 2
- Disclaimer 2
- Warranty 2
- Table of Contents 7
- Chapter 3 8
- Chapter 4 9
- VT100 Interface 9
- Appendix A 10
- Specifications 10
- Appendix B 11
- SNMP Agent 11
- WANsuite 6x30 12
- About this Manual 13
- Telephone 14
- Internet 15
- Introduction 17
- Features of the WANsuite 18
- 6x30 Product Family 18
- SNMP Management 19
- Features Summary 20
- Front Panel 20
- WANsuite 6130 Rear Panel 21
- Indicator 21
- Description 21
- Ethernet LED Indicators 23
- Power Failure 24
- NSTALLATION 25
- Installation Wizard 26
- Installation 27
- Web Server Interface 29
- Layout of Interface Screens 30
- Figure 3.1 31
- Network Screens 33
- Figure 3.5 37
- Figure 3.6 37
- WANsuite 6230 Network Screen 38
- WANsuite 6430 Network Screen 39
- Network Services 41
- Service Details Button 41
- Interface Details Button 41
- Type Details Button 41
- Figure 3.11 42
- Figure 3.17 48
- Supervisory Screen 54
- Service Details Screen 55
- Delete Service Button 56
- ATM Virtual Channels Screen 60
- Figure 3.30 62
- Figure 3.31 62
- Figure 3.35 66
- Circuits Screen 72
- Static Routes Screen 75
- Route Details Screen 76
- Figure 3.55 86
- Figure 3.56 87
- Figure 3.57 87
- Figure 3.60 89
- Software Upgrade 94
- Figure 3.67 95
- Password 96
- Log Out Screen 97
- Cursor Controls 100
- NOTICE: 100
- Field Types 100
- Menu Structure 101
- CAUTION: 101
- System Screen 102
- Maintenance Reset 103
- Save and Restart 103
- Config Screens 104
- VT100 Interface 4-7 105
- Performance Screens 107
- Performance 30 Day Screen 108
- Figure 4.9 109
- Configuration Profiles 110
- Figure 4.10 111
- Alarm Profiles Screen 112
- Alarm Profile Details Screen 114
- Span Endpoints Screen 115
- Span Endpoint Details Screen 116
- Figure 4.16 117
- Figure 4.17 118
- 15-Minute and 1-Day Intervals 119
- Serial Screen 119
- VT100 Interface 4-23 121
- Ethernet (IP Details) Screen 122
- Service Details Screen 124
- IP Service Details Screen 125
- ATM Service Details Screen 125
- ATM Statistics Screen 126
- Figure 4.25 127
- Adding a New Virtual Channel 128
- Figure 4.26 129
- Figure 4.27 129
- HDLC/PPP Service 130
- Service Aware 131
- Rule Config Screen 131
- Figure 4.31 133
- SNMP Details Screen 134
- Diagnostics Screen 134
- Trap Log Screen 135
- Top Talkers Screen 136
- IP Gateway Screen 137
- RIP Parameters 138
- OSPF Parameters 138
- Circuit Table Screen 139
- Circuit Details Screen 139
- Static Route Table Screen 141
- Routes Details Screen 142
- Dynamic Route Table Screen 143
- Static ARP Table Screen 144
- ARP Details Screen 145
- Trusted Neighbors Screen 146
- Area Table Screen 147
- Area Details Screen 147
- Virtual Link Table Screen 149
- Virtual Link Details Screen 150
- NAT Details Screen 151
- 4-54 WANsuite 6x30 152
- Figure 4.51 153
- NAT Ports Screen 154
- NAT Port Details Screen 155
- NAT Port Status Table Screen 155
- Figure 4.56 156
- DHCP Details Screen 157
- Figure 4.58 158
- DHCP Hosts Screen 159
- Static Entries Screen 159
- IP Address List Screen 160
- IP Address Status Screen 161
- 4-64 WANsuite 6x30 162
- PECIFICATIONS 163
- Facility Data Link (FDL) 164
- 10/100 Ethernet 164
- Supervisory Port 164
- Industry Listings 165
- WANsuite 6230 Specifications 166
- Mechanical 167
- Environmental 167
- Standards 168
- WANsuite 6430 Specifications 169
- Standard Equipment 172
- Optional Equipment 172
- (Packet Use Only) 173
- 10/100 ETHERNET 174
- NETWORK 175
- SUPERVISORY PORT 175
- SNMP Configuration Parameters 177
- SNMP MIBs 177
- SNMP Trap Configuration 178
Powiązane produkty i podręczniki dla Sprzęt komputerowy Verilink WANsuite 6x30 (34-00315.B) Product Manual
Sprzęt komputerowy Verilink WANsuite 6450 (34-00326) Product Manual Instrukcja Użytkownika
(205 strony)
(205 strony)
Sprzęt komputerowy Verilink 1041 (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink 1042 (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink 1050 (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink WANsuite 7205 (34-00317.B) Product Manual Instrukcja Użytkownika
(221 strony)
(221 strony)
Sprzęt komputerowy Verilink 1251 (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink 1250 (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink 1544 (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink 1544E (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
Sprzęt komputerowy Verilink 1544N (CG) Configuration/Installation Guide Instrukcja Użytkownika
(2 strony)
(2 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.027 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji